Powermate PM0601250 Manuel d'utilisateur télécharger pdf (Page 2)

*22 HP Subaru OHV engine

*Cast-iron cylinder sleeve

*Low oil sensor

*Receptacles on control panel

*Electric Start

*Idle control

*CordKeeper™

*8 gallon plastic fuel tank

*Portability Kit

A.120 Volt GFCI Receptacle

Ground Fault Circuit Interrupter duplex receptacle is rated

so that a total of 20 amps may be drawn regardless of whether

both halves or just one receptacle is used. This receptacle may

be used along with other receptacles provided the generator is

not overloaded and total power drawn is kept within nameplate

ratings.

Ground Fault Circuit Interrupter

(Conforms to U.L 943, Class A and NEC requirements)

This device protects you against hazardous electrical

shock that may be caused if your body becomes a path through

which electricity travels to reach ground. This could happen

when you touch an appliance or cord that is “ live “ through

faulty mechanism, damp or worn insulation, etc.

The GFCI receptacle cannot be reset once tripped, unless

the generator is running and power is available to it. Test

regularly to assure proper operation.

B.120 Volt, 30 Ampere Twistlock Receptacle

You may draw a maximum of 30 amps from this

receptacle. If other receptacles are used at the same time,

total power used must be kept within nameplate ratings.

C.120/240 Volt Heavy Duty Receptacle

This receptacle is rated at 50 amps but the current must be

limited to the nameplate rating. If this receptacle is used along

with the 120 volt receptacles, the total load drawn must not

exceed the nameplate ratings.

D.Circuit Breakers

The receptacles are protected by an AC circuit breaker. If

the generator is overloaded or an external short circuit occurs,

the circuit breaker will trip. If this occurs, disconnect all

electrical loads and try to determine the cause of the problem

before attempting to use the generator again. If overloading

causes the circuit breaker to trip, reduce the load. NOTE:

Continuous tripping of the circuit breaker may cause

damage to generator or equipment. The circuit breaker may

be reset by pushing the button of the breaker.

E.Idle Control Switch

The Idle Control circuit is designed to extend engine life

and improve fuel usage by slowing the engine down to

approximately 2000 RPM in a “No Load” condition. The noise is

also greatly reduced during this condition.

When power is required from the generator an electronic

control module automatically senses current flow in the

electrical outlet and allows the engine to return to full speed or

standard operating condition. Likewise, when the load is

removed, the generator will automatically return to the idle

condition after a 4-5 second delay.

A convenient switch is mounted in the control panel for

easy access and will disable the Idle Control circuitry when in

the off position.

NOTE: A 12V battery must be installed in order for the

idle control to function.

F.CordKeeper™ Restraint

The CordKeeper™ restraint is a unique

feature used to prevent plugs from being

pulled out of the receptacles.

Refer to the appropriate diagram for proper connection of

power cord wires to the plug terminals.

CAUTION: Insure that the power cord used is

well insulated and has a sufficient rating to

match that of the plug.

English

CONTROL PANEL

MAJOR GENERATOR FEATURES

POWER CORD CONNECTIONS

120 Volt 30 Amp Plug

120/240 Volt Heavy Duty Plug

1 2 3 4 5 6 7 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Powermate PM0601250 Manuel d'utilisateur Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Générateurs Powermate PM0601250